Siemens Repair in Rayong

G120 (CU240E / PM240-2)

G120 is a Siemens series. CU240E and PM240-2 are the G120 equipment covered here. CU320 was also repaired and is listed separately from this G120 group. Brand and model names identify the equipment.

• —Models previously repaired and covered by this page: 6RA80, CU240E and PM240-2.
• —Another model previously repaired: CU320, listed separately from the G120 equipment covered here.
• —Send the complete model number from the nameplate and the symptoms so that the scope can be assessed before submission.
• —Experience with these models does not establish coverage of every model in their respective series.

6RA80

Based on our repair experience, speed measurement components and the control board are inspection directions when a 6RA80 displays F60031.

This is repair experience, rather than a Siemens manual definition of the code. It does not identify the failed component in an individual unit. Equipment information and physical inspection are needed before reaching a conclusion.

Information to prepare before inspection

1. 01A clear nameplate photograph showing the complete model number.
2. 02For G120 equipment, the control unit and power module model numbers separately, if available.
3. 03Photographs of the display and the fault code exactly as shown.
4. 04A description of the symptoms and when they occur, such as during startup or operation.
5. 05External photographs and any known repair or component replacement history.

Remove unrelated customer information from photographs before sending them.

Submission process

1. 01Contact us by phone or email with the information above.
2. 02The information supports an initial assessment.
3. 03Inspect the physical equipment after arrival.
4. 04Confirm the work scope and quotation after inspection.

Inspection and testing scope must be confirmed for each unit.